Adlink EXP-ETH8 Instrukcja Użytkownika

TME-EXP-ETH8-1V3 Revision 1.3 / February 14 ©LiPPERT Adlink Technology GmbH Hans-Thoma-Str. 11 D-68163 Mannheim http://www.adlinktech.com EXP-ET

TME-EXP-ETH MecFront Side vSystem TH8-1V3 chanical viview view m stack-up viNoteiew iew with Hurre For detaileddepartmenticane-QM57 ad mechanical t

TME-EXP-ETH8-1V3 Rev 1.3 Page 7 of 17 Metrics on Top

TME-EXP-ETH8-1V3 Rev 1.3 Page 8 of 17 2 Getting Started 2.1 Connector Locations Top Port 8 X27 Port 7 X26 Port 6 X25Port 4 X23 Port 3 X

TME-EXP-ETH8-1V3 Rev 1.3 Page 9 of 17 Bottom PC/104 Plus PCIe/104Express

TME-EXP-ETH8-1V3 Rev 1.3 Page 10 of 17 2.2 Hardware Setup Caution Be sure to observe the EMC security measures. Make sure you are always a

TME-EXP-ETH8-1V3 Rev 1.3 Page 11 of 17 3 Module Description 3.1 Gigabit Ethernet Controller On board there are eight gigabit Ethernet control

TME-EXP-ETH8-1V3 Rev 1.3 Page 12 of 17 3.3 PC/104-Plus Bus Connector The PC/104-plus bus is not used on that module. The mounted connector for

TME-EXP-ETH8-1V3 Rev 1.3 Page 13 of 17 Pin A B C D 26 n.c. n.c. GND n.c. 27 n.c. n.c. n.c. GND 28 GND n.c. n.c. n.c. 29 n.c.

TME-EXP-ETH8-1V3 Rev 1.3 Page 14 of 17 3.4 PCI/104 Express Bus Interface The EXP-ETH8 uses x16 link of the PCI/104-Express bus. Which link is

TME-EXP-ETH8-1V3 Rev 1.3 Page 15 of 17 31 Pex1_2 Rn 32 Pex1_3 Rn 33 GND 34 GND 35 Pex1_1Clkp 36 Pex1_0Clkp 37 Pex1_1Clkn 38 Pex1_0Clkn 39 +

Technical Manual EXP-ETH8 LiPPERT Document: TME-EXP-ETH8-1V3 Revision 1.3 Copyright © 2009 LiPPERT Adlink Technology GmbH, All rights reserved Cont

TME-EXP-ETH8-1V3 Rev 1.3 Page 16 of 17 Pin Signal Pin Signal 53 WAKE#+5V 54PEG EN#55 GND 56 GND 57 Pex16_0T(8)p 58 Pex16_0T(0)p 59 Pex16_

TME-EXP-ETH8-1V3 Rev 1.3 Page 17 of 17 127 Pex16_0R(11)p 128 Pex16_0R(3)p 129 Pex16_0R(11)n 130 Pex16_0R(3)n 131 GND 132 GND 133 Pex16_0R(12)p

TME-EXP-ETH8-1V3 Rev 1.3 Appendix A Appendix A, Contact Information Headquarters LiPPERT ADLINK Technology GmbH Hans-Thoma-Straße 11 68163 M

TME-EXP-ETH8-1V3 Rev 1.3 Appendix B Appendix B, Additional Information B.1 Additional Reading Datasheet of the PEX8618 at http://www.plxtech

TME-EXP-ETH8-1V3 Rev 1.3 Appendix C Appendix C, Getting Help Should you have technical questions that are not covered by the respective manua

TME-EXP-ETH8-1V3 Rev 1.3 Appendix D Appendix D, Revision History Filename Date Edited by Change TME-EXP-ISO-COM8-R0V0.doc 2009-12-10 CS

TME-EXP-ETH8-1V3 Rev 1.3 i Table of Contents 1 Overview 11.1 Introduction ...

TME-EXP-ETH8-1V3 Rev 1.3 ii 3.4 PCI/104 Express Bus Interface ...

TME-EXP-ETH8-1V3 Rev 1.3 Page 1 of 17 1 Overview 1.1 Introduction The EXP-ETH8 is an Add-on Module conforming to the EPIC ExpressTM Specifica

TME-EXP-ETH8-1V3 Rev 1.3 Page 2 of 17 PHY  Compliant with the 1 Gb/s IEEE 802.3 802.3u 802.3ab specifications  IEEE 802.3ab auto negotiation

TME-EXP-ETH8-1V3 Rev 1.3 Page 3 of 17 1.2 Ordering Information EXP-ETH8 Models Order number Description 714-0004-10 EXP-ETH8 with eight galv

TME-EXP-ETH8-1V3 Rev 1.3 Page 4 of 17 1.3 Specifications Electrical Specifications Supply voltage +3.3V DC and +5 V DC (via PCI/104-Express B

TME-EXP-ETH8-1V3 Rev 1.3 Page 5 of 17 1.4 Mechanical Dimensions (L x W) 165 mm x 115 mm Height max. 17 mm on top side above PCB max. 12 mm